Wiki entry on Linear/Pressure Advance Tower

[dotdash32]

I was doing another calibration print, and realized there was section that I left out when initially writing the documentation. When changing print settings, Cura changes outer_wall_speed to be half print_speed, which can cause some problems when testing linear advance on the outside of the test print. I modified my fork of the wiki to include a paragraph about this, and I believe it also decreases the print time, but would love independent verification on that.

[5axes]

If someone could give some advice or can confirme this point, his answer would be welcome. As I'm not using Linear/Pressure Advance on my machine I cannot confirm this point myself.

[dotdash32]

Unsure if I was completely clear in the OP, but here is the relevant part from Klipper's docs:

It can be useful to set the external perimeter speed to be the same speed as the rest of the print, but it is not a requirement.

When I did the test, it was much easier to see the effects of the test with a high speed and therefore high flow on the outer wall since that is the most visible part.