hw_config.h

/**
  ******************************************************************************
  * @file    hw_config.h
  * @author  MCD Application Team
  * @version V1.1.0
  * @date    20-September-2012
  * @brief   Hardware Configuration & Setup.
  ******************************************************************************
  * @attention
  *
  * <h2><center>&copy; COPYRIGHT 2012 STMicroelectronics</center></h2>
  *
  * Licensed under MCD-ST Liberty SW License Agreement V2, (the "License");
  * You may not use this file except in compliance with the License.
  * You may obtain a copy of the License at:
  *
  *        http://www.st.com/software_license_agreement_liberty_v2
  *
  * Unless required by applicable law or agreed to in writing, software
  * distributed under the License is distributed on an "AS IS" BASIS,
  * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
  * See the License for the specific language governing permissions and
  * limitations under the License.
  *
  ******************************************************************************
  */

/* Define to prevent recursive inclusion -------------------------------------*/
#ifndef __HW_CONFIG_H
#define __HW_CONFIG_H

/* Includes ------------------------------------------------------------------*/
#ifdef USART_USE_USB
#include "usb_type.h"
#endif //#ifdef USART_USE_USB

#include "stm32f30x.h"


/* Exported types ------------------------------------------------------------*/
/* Exported constants --------------------------------------------------------*/
/* Exported macro ------------------------------------------------------------*/
/* Exported define -----------------------------------------------------------*/
#define MASS_MEMORY_START     0x04002000
#define BULK_MAX_PACKET_SIZE  0x00000040
#define LED_ON                0xF0
#define LED_OFF               0xFF

#define USART_RX_DATA_SIZE   2048

/* Exported functions ------------------------------------------------------- */
void Set_System(void);
void GPIO_AINConfig(void);
void GyroExtiConfig(void);


#ifdef USART_USE_USB
void Set_USBClock(void);
void Enter_LowPowerMode(void);
void Leave_LowPowerMode(void);
void USB_Interrupts_Config(void);
void USB_Cable_Config (FunctionalState NewState);
void Handle_USBAsynchXfer (void);
void USB_Send_Data(uint8_t data);
void Get_SerialNum(void);
#endif //#ifdef USART_USE_USB

int16_t myPrintf(const char * format, ...);

#ifdef USART_USE_USART
extern uint8_t USART_TxBuffer[60];
void USART_InitDMATransfer(int16_t bufferSize);
void GyroExtiConfig(void);
#endif //#ifdef USART_USE_USART

#endif  /*__HW_CONFIG_H*/

/************************ (C) COPYRIGHT STMicroelectronics *****END OF FILE****/