Stm32cubeide and stlink v2

[peterscottie]

When I try to debug
STM32Cube IDE pops up a dialog box saying could not verify ST device. Ive tried updating the firmware and it still does the same.
.
However Openocd -d2 says this

    http://openocd.org/doc/doxygen/bugs.html

Info : auto-selecting first available session transport "hla_swd". To override use 'transport select '.
Info : The selected transport took over low-level target control. The results might differ compared to plain JTAG/SWD
Info : DEPRECATED target event trace-config; use TPIU events {pre,post}-{enable,disable}
Info : Listening on port 6666 for tcl connections
Info : Listening on port 4444 for telnet connections
Info : clock speed 1000 kHz
Info : STLINK V2J45S7 (API v2) VID:PID 0483:3748
Info : Target voltage: 3.126316
Info : [stm32f1x.cpu] Cortex-M3 r1p1 processor detected
Info : [stm32f1x.cpu] target has 6 breakpoints, 4 watchpoints
Info : starting gdb server for stm32f1x.cpu on 3333
Info : Listening on port 3333 for gdb connections
[stm32f1x.cpu] halted due to breakpoint, current mode: Thread
xPSR: 0x61000000 pc: 0x08008278 psp: 0x20000678
Info : accepting 'gdb' connection on tcp/3333
Info : device id = 0x10036414
Info : flash size = 256 KiB
Error: Invalid AP#0x0
Info : dropped 'gdb' connection

Many Thanks
Any Ideas?