WebTop Serial adapter

• Disclaimer
• Bill of materials
• Quick start
• Wiring
• Web interface

SoftRF WebTop Serial is an extremely low budget (less than 5 USD) Wi-Fi Wireless Access Point add-on, which is applicable for almost every of wired SoftRF Editions, such as:

• Uni ,
• Dongle ,
• Mini ,
• Retro ,
• and, possibly, Raspberry. ¹

¹ - unlike other Editions, Raspberry one have no support of NMEA remote control feature at this time.

The WebTop Serial provides a Web interface and data transport to:

• monitor status of connected SoftRF device , and
• change settings , and
• deliver own position and air traffic data from the SoftRF device to a smartphone/tablet by UDP over Wi-Fi.

The WebTop is based upon a third-party's hardware - "Serial WiFi" adapter, which is available for purchase from numerous online webstores:

Disclaimer

In general a lot of Chinese DIY electronics manufacturers are known to behave this way:

• sometimes they may not apply necessary Q.C. before releasing of a product from factory ;
• they may arbitrary change schematics and electronic components from one batch to the next one ;
• they may terminate manufacturing of a board just few months after initial production.

Because of that, author of SoftRF:

• will reject any hardware related claims associated with "Serial WiFi" adapter. Ask for support from seller or manufacturer ;
• reserves the right to suspend or terminate support of "Serial WiFi" adapter in the firmware at any time.

If you have issues with bringing up your new "Serial WiFi" adapter or just not happy with the board - be prepared to execute your Purchase Protection plan.

Bill of materials

Required

Number	Part	Qty	Picture	Source
1	Serial WiFi v1.0	1		AliExpress 1 2

Recommended

In order to install the SoftRF WebTop Serial firmware into the "Serial WiFi adapter" at first time - you will need to utilize a USB to serial converter.

Number	Part	Qty	Picture	Source
2	40 pcs. female DuPont jumper wires	1		AliExpress
3	CP2102 USB 2.0 to TTL UART serial converter	1		AliExpress

Quick start

Use these instructions to start operating with your delivered WebTop Serial Wi-Fi adapter.

Wiring

Dongle Edition

Web interface

Status

1. Connect your Tablet/Cellphone to SoftRF Wi-Fi Access Point.
   SSID: SoftRF-XXXXXX
   Key: 12345678
   

2. Open up a browser then proceed to this URL: http://192.168.1.1

3. A page like this should come up:
   

Settings

Tap on the Settings button to proceed to settings menu.

Settings description is located there.