Problem to connect to AP

[BigDi]

In version 0.3 is it "hard" to connect to the access Point. After some tries I got it working. But at the moment I have flashed again the the ESP will not connect. When the connect is working then I get a dump. I only see something with python.. After a couple of reset (doing nothing else) it working now.

Output from console:

SSID: XXXXXX
Pass: ********
wrong action: , (updating: 1, connectingNow: 1)
SSID: XXXXXX
Pass: ********
wrong action: , (updating: 1, connectingNow: 1)
SSID: XXXXXX
Pass: ********
wrong action: , (updating: 1, connectingNow: 1)
SSID: XXXXXX
Pass: ********
wrong action: , (updating: 1, connectingNow: 1)
SSID: XXXXXX
Pass: ********
wrong action: , (updating: 1, connectingNow: 1)
SSID: XXXXXX
Pass: ********
wrong action: , (updating: 1, connectingNow: 1)
SSID: XXXXXX
Pass: ********
wrong action: , (updating: 1, connectingNow: 1)
SSID: XXXXXX
Pass: ********
wrong action: , (updating: 1, connectingNow: 1)
reconnect
state: 2 -> 0 (0)
f r0, scandone
state: 0 -> 2 (b0)
SSID: XXXXXX
Pass: ********
state: 2 -> 3 (0)
state: 3 -> 5 (10)
add 0
aid 5
cnt
SSID: XXXXXX
Pass: ********
wrong action: XXXXXX XXXXXX, (updating: 1, connectingNow: 1)
SSID: XXXXXX
Pass: ********
wrong action: XXXXXX XXXXXX, (updating: 1, connectingNow: 1)
SSID: XXXXXX
Pass: ********
wrong action: XXXXXX XXXXXX, (updating: 1, connectingNow: 1)
Station configuration was updated to: XXXXXX
f r0, SSID: XXXXXX
Pass: XXXXXX
SSID: XXXXXX
Pass: XXXXXX