-
Notifications
You must be signed in to change notification settings - Fork 268
/
axi_err_slv.sv
261 lines (243 loc) · 8.31 KB
/
axi_err_slv.sv
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
// Copyright 2019 ETH Zurich and University of Bologna.
// Copyright and related rights are licensed under the Solderpad Hardware
// License, Version 0.51 (the "License"); you may not use this file except in
// compliance with the License. You may obtain a copy of the License at
// http://solderpad.org/licenses/SHL-0.51. Unless required by applicable law
// or agreed to in writing, software, hardware and materials distributed under
// this License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR
// CONDITIONS OF ANY KIND, either express or implied. See the License for the
// specific language governing permissions and limitations under the License.
//
// Authors:
// - Wolfgang Roenninger <[email protected]>
// - Andreas Kurth <[email protected]>
// - Matheus Cavalcante <[email protected]>
// AXI Error Slave: This module always responds with an AXI error for transactions that are sent to
// it. This module optionally supports ATOPs if the `ATOPs` parameter is set.
module axi_err_slv #(
parameter int unsigned AxiIdWidth = 0, // AXI ID Width
parameter type axi_req_t = logic, // AXI 4 request struct, with atop field
parameter type axi_resp_t = logic, // AXI 4 response struct
parameter axi_pkg::resp_t Resp = axi_pkg::RESP_DECERR, // Error generated by this slave.
parameter int unsigned RespWidth = 32'd64, // Data response width, gets zero extended or truncated to r.data.
parameter logic [RespWidth-1:0] RespData = 64'hCA11AB1EBADCAB1E, // Hexvalue for data return value
parameter bit ATOPs = 1'b1, // Activate support for ATOPs. Set to 1 if this slave could ever get an atomic AXI transaction.
parameter int unsigned MaxTrans = 1 // Maximum # of accepted transactions before stalling
) (
input logic clk_i, // Clock
input logic rst_ni, // Asynchronous reset active low
input logic test_i, // Testmode enable
// slave port
input axi_req_t slv_req_i,
output axi_resp_t slv_resp_o
);
typedef logic [AxiIdWidth-1:0] id_t;
typedef struct packed {
id_t id;
axi_pkg::len_t len;
} r_data_t;
axi_req_t err_req;
axi_resp_t err_resp;
if (ATOPs) begin
axi_atop_filter #(
.AxiIdWidth ( AxiIdWidth ),
.AxiMaxWriteTxns ( MaxTrans ),
.axi_req_t ( axi_req_t ),
.axi_resp_t ( axi_resp_t )
) i_atop_filter (
.clk_i,
.rst_ni,
.slv_req_i ( slv_req_i ),
.slv_resp_o ( slv_resp_o ),
.mst_req_o ( err_req ),
.mst_resp_i ( err_resp )
);
end else begin
assign err_req = slv_req_i;
assign slv_resp_o = err_resp;
end
// w fifo
logic w_fifo_full, w_fifo_empty;
logic w_fifo_push, w_fifo_pop;
id_t w_fifo_data;
// b fifo
logic b_fifo_full, b_fifo_empty;
logic b_fifo_push, b_fifo_pop;
id_t b_fifo_data;
// r fifo
r_data_t r_fifo_inp;
logic r_fifo_full, r_fifo_empty;
logic r_fifo_push, r_fifo_pop;
r_data_t r_fifo_data;
// r counter
logic r_cnt_clear, r_cnt_en, r_cnt_load;
axi_pkg::len_t r_current_beat;
// r status
logic r_busy_d, r_busy_q, r_busy_load;
//--------------------------------------
// Write Transactions
//--------------------------------------
// push, when there is room in the fifo
assign w_fifo_push = err_req.aw_valid & ~w_fifo_full;
assign err_resp.aw_ready = ~w_fifo_full;
fifo_v3 #(
.FALL_THROUGH ( 1'b1 ),
.DEPTH ( MaxTrans ),
.dtype ( id_t )
) i_w_fifo (
.clk_i ( clk_i ),
.rst_ni ( rst_ni ),
.flush_i ( 1'b0 ),
.testmode_i ( test_i ),
.full_o ( w_fifo_full ),
.empty_o ( w_fifo_empty ),
.usage_o ( ),
.data_i ( err_req.aw.id ),
.push_i ( w_fifo_push ),
.data_o ( w_fifo_data ),
.pop_i ( w_fifo_pop )
);
always_comb begin : proc_w_channel
err_resp.w_ready = 1'b0;
w_fifo_pop = 1'b0;
b_fifo_push = 1'b0;
if (!w_fifo_empty && !b_fifo_full) begin
// eat the beats
err_resp.w_ready = 1'b1;
// on the last w transaction
if (err_req.w_valid && err_req.w.last) begin
w_fifo_pop = 1'b1;
b_fifo_push = 1'b1;
end
end
end
fifo_v3 #(
.FALL_THROUGH ( 1'b0 ),
.DEPTH ( unsigned'(2) ), // two placed so that w can eat beats if b is not sent
.dtype ( id_t )
) i_b_fifo (
.clk_i ( clk_i ),
.rst_ni ( rst_ni ),
.flush_i ( 1'b0 ),
.testmode_i ( test_i ),
.full_o ( b_fifo_full ),
.empty_o ( b_fifo_empty ),
.usage_o ( ),
.data_i ( w_fifo_data ),
.push_i ( b_fifo_push ),
.data_o ( b_fifo_data ),
.pop_i ( b_fifo_pop )
);
always_comb begin : proc_b_channel
b_fifo_pop = 1'b0;
err_resp.b = '0;
err_resp.b.id = b_fifo_data;
err_resp.b.resp = Resp;
err_resp.b_valid = 1'b0;
if (!b_fifo_empty) begin
err_resp.b_valid = 1'b1;
// b transaction
b_fifo_pop = err_req.b_ready;
end
end
//--------------------------------------
// Read Transactions
//--------------------------------------
// push if there is room in the fifo
assign r_fifo_push = err_req.ar_valid & ~r_fifo_full;
assign err_resp.ar_ready = ~r_fifo_full;
// fifo data assignment
assign r_fifo_inp.id = err_req.ar.id;
assign r_fifo_inp.len = err_req.ar.len;
fifo_v3 #(
.FALL_THROUGH ( 1'b0 ),
.DEPTH ( MaxTrans ),
.dtype ( r_data_t )
) i_r_fifo (
.clk_i ( clk_i ),
.rst_ni ( rst_ni ),
.flush_i ( 1'b0 ),
.testmode_i( test_i ),
.full_o ( r_fifo_full ),
.empty_o ( r_fifo_empty ),
.usage_o ( ),
.data_i ( r_fifo_inp ),
.push_i ( r_fifo_push ),
.data_o ( r_fifo_data ),
.pop_i ( r_fifo_pop )
);
always_comb begin : proc_r_channel
// default assignments
r_busy_d = r_busy_q;
r_busy_load = 1'b0;
// r fifo signals
r_fifo_pop = 1'b0;
// r counter signals
r_cnt_clear = 1'b0;
r_cnt_en = 1'b0;
r_cnt_load = 1'b0;
// r_channel
err_resp.r = '0;
err_resp.r.id = r_fifo_data.id;
err_resp.r.data = RespData;
err_resp.r.resp = Resp;
err_resp.r_valid = 1'b0;
// control
if (r_busy_q) begin
err_resp.r_valid = 1'b1;
err_resp.r.last = (r_current_beat == '0);
// r transaction
if (err_req.r_ready) begin
r_cnt_en = 1'b1;
if (r_current_beat == '0) begin
r_busy_d = 1'b0;
r_busy_load = 1'b1;
r_cnt_clear = 1'b1;
r_fifo_pop = 1'b1;
end
end
end else begin
// when not busy and fifo not empty, start counter err gen
if (!r_fifo_empty) begin
r_busy_d = 1'b1;
r_busy_load = 1'b1;
r_cnt_load = 1'b1;
end
end
end
always_ff @(posedge clk_i, negedge rst_ni) begin
if (!rst_ni) begin
r_busy_q <= '0;
end else if (r_busy_load) begin
r_busy_q <= r_busy_d;
end
end
counter #(
.WIDTH ($bits(axi_pkg::len_t))
) i_r_counter (
.clk_i ( clk_i ),
.rst_ni ( rst_ni ),
.clear_i ( r_cnt_clear ),
.en_i ( r_cnt_en ),
.load_i ( r_cnt_load ),
.down_i ( 1'b1 ),
.d_i ( r_fifo_data.len ),
.q_o ( r_current_beat ),
.overflow_o( )
);
// pragma translate_off
`ifndef VERILATOR
`ifndef XSIM
initial begin
assert (Resp == axi_pkg::RESP_DECERR || Resp == axi_pkg::RESP_SLVERR) else
$fatal(1, "This module may only generate RESP_DECERR or RESP_SLVERR responses!");
end
default disable iff (!rst_ni);
if (!ATOPs) begin : gen_assert_atops_unsupported
assume property( @(posedge clk_i) (slv_req_i.aw_valid |-> slv_req_i.aw.atop == '0)) else
$fatal(1, "Got ATOP but not configured to support ATOPs!");
end
`endif
`endif
// pragma translate_on
endmodule