Wishfish

Wishfish is a SSH wrapper for macOS that binds to a specific network interface, e. g. Wi-Fi.

Warning

This is alpha-quality software. If you don’t know what this means, do not use Wishfish.

If you do use Wishfish, be advised that it is largely untested. That said, it’s only a tiny wrapper so I expect it to work well enough.

System requirements

To use Wishfish, you need OS X 10.11 El Capitan, macOS 10.12 Sierra, or a later macOS version.

Purpose

I use this command to force SSH to run over the Wi-Fi interface even if there is another network interface with higher priority (e. g. Ethernet).

In other words, wishfish allows you to disconnect an Ethernet cable from your Mac without disconnecting your active SSH sessions as long as you’re on Wi-Fi.

Without wishfish, you’d need to either configure your Wi-Fi interface to have the highest priority, which you may not want at all times because your Ethernet is faster; or, you’d need to pass your own link-local IP address to the ssh command so it binds to that interface. The latter is especially cumbersome because you may not want to memorize your local IP address, or you may not find it acceptable that the IP address can change.

Installation

1. Make sure you have Homebrew installed.

2. Run brew install claui/public/wishfish if you haven’t already done so.

Usage

There are two executables in this package: wishfish and ipv6_address.

Using wishfish

Run the wishfish command from the Terminal to establish a SSH connection. As the first command-line argument, pass the name of the interface you wish to bind, and then append your ssh arguments:

$ wishfish <interface> <ssh_arguments>

For example:

$ wishfish en0 -p 22 [email protected]

Using ipv6_address

This package depends on another CLI tool ipv6_address, which tells you one of your current IPv6 addresses bound to specific network interface. Pass the interface name as the single command-line argument:

$ bin/ipv6_address

Running ipv6_address results in one of the following two scenarios:

• ipv6_address finds one or more IPv6 addresses currently bound to the given interface. It then prints one of those addresses to standard output, and the exit status will be 0.

• ipv6_address does not find an IPv6 address to the given interface, or runs into another error. Either way, it does not print anything on standard output, and exits with a status code of 1.

License

Copyright (c) 2017 Claudia [email protected]

Permission to use, copy, modify, and/or distribute this software for any purpose with or without fee is hereby granted, provided that the above copyright notice and this permission notice appear in all copies.

THE SOFTWARE IS PROVIDED "AS IS" AND THE AUTHOR DISCLAIMS ALL WARRANTIES WITH REGARD TO THIS SOFTWARE INCLUDING ALL IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS. IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY SPECIAL, DIRECT, INDIRECT, OR CONSEQUENTIAL DAMAGES OR ANY DAMAGES WHATSOEVER RESULTING FROM LOSS OF USE, DATA OR PROFITS, WHETHER IN AN ACTION OF CONTRACT, NEGLIGENCE OR OTHER TORTIOUS ACTION, ARISING OUT OF OR IN CONNECTION WITH THE USE OR PERFORMANCE OF THIS SOFTWARE.