Open 60

Table of Contents

• Introduction
• Features
• Required hardware
• Disclaimer

Introduction

Back again with another fully open source keyboard project. This time with a 60% WKL layout.

Features

• 60% Layout with WKL Blockers.
• Top mounted, with an option for an o-ring gasket.
• Seamless side profile.
• USB-C with Unified Daughterboard
• SKUF Feet.
• Weight with engravings.
• Very low front height (17.8mm AFH w/o feet).
• Curved "Cherry lip".

Required-Hardware

• Everything from the "case-files" directory.
• A PCB of your choosing. I recommend the SST60, however any Bakeneko supporting PCB should work.
• A Unified Daughterboard or equivalent (like the hiney DB).
• Screws:
  • 4 M3x10mm screws with a 5.5mm head diameter. These for example.
  • 4 M3x8mm screws with a 5.5mm head diameter and <2mm head height. These for example.
  • 3 M3x6mm countersunk screws with a 5.5mm head diameter. These for example.
  • 10 M2x6mm screws with a <2mm head diameter. These for example.
• SKUF Feet.
• Optional:
  • O-ring for gasket mounting. Like This 50a one, or this 70a one, or this 90a one.
  • Any type of foam you might want. (I will judge you.)

Disclaimer

• I do not offer any sort of warranty for this, nor can I be held liable if something goes wrong.
• Renders are not fully representative of the final product.
• Please, PLEASE look over the design before you do anything with it, it's possible and very likely that there are some errors, I'm just a human.