Clarify PIO define is optional in docs. (qmk#22339)

stanrc85 · Oct 26, 2023 · e0c00c3 · e0c00c3
1 parent d289268
commit e0c00c3
Show file tree

Hide file tree

Showing 2 changed files with 2 additions and 2 deletions.
diff --git a/docs/serial_driver.md b/docs/serial_driver.md
@@ -235,7 +235,7 @@ Where 'n' matches the peripheral number of your selected USART on the MCU.
 
 The `PIO` subsystem is a Raspberry Pi RP2040 specific implementation, using the integrated PIO peripheral and is therefore only available on this MCU. Because of the flexible nature of the PIO peripherals, **any** GPIO pin can be used as a `TX` or `RX` pin. Half-duplex and Full-duplex operation is fully supported. The Half-duplex operation mode uses the built-in pull-ups and GPIO manipulation on the RP2040 to drive the line high by default. An external pull-up is therefore not necessary.
 
-Configure the hardware via your config.h:
+You may optionally switch the PIO peripheral used with the following define in config.h:
 ```c
 #define SERIAL_PIO_USE_PIO1 // Force the usage of PIO1 peripheral, by default the Serial implementation uses the PIO0 peripheral
 ```

diff --git a/docs/ws2812_driver.md b/docs/ws2812_driver.md
@@ -170,7 +170,7 @@ To configure it, add this to your rules.mk:
 WS2812_DRIVER = vendor
 ```
 
-Configure the hardware via your config.h:
+You may optionally switch the PIO peripheral used with the following define in config.h:
 ```c
 #define WS2812_PIO_USE_PIO1 // Force the usage of PIO1 peripheral, by default the WS2812 implementation uses the PIO0 peripheral
 ```